Skip to main content

Configure Command probe

This topic guides you on how to use the command probe inline and how to configure source parameter with the command probe. You can follow the same steps for other resilience probes.

Before you begin, review the following​

In the final step of creating a probe, provide details specific to that resilience probe (such as a command for the command probe, a query to the Prometheus probe, and so on).

Configure Command Probe​

You can configure a probe using the YAML manifest or from the UI. When you use the UI to configure a probe, the probe attributes are minified in the corresponding YAML, and are referred using the probeID.

In this example, you will specify details of the command probe from the UI.

  1. In the Probe Details modal, enter a command in the Command field.

    Step 1

  2. Enter the Type, Comparison criteria, and the Value. Click Configure Properties. Provide other values like Timeout, Interval, Attempt, Polling Interval, and Verbosity. Click Setup Probe.

    Step 2

Go to sample YAML inline to tune a resilience probe from the manifest.

Configure Command probe with source parameter​

  1. Enter the Type, Comparison criteria, Value. Toggle to switch on the Source mode. Select Setup probe.

    Step 2

tip

Alongside the source parameter, you can provide other specifications (for example, imagePullPolicy, custom image, environment variables, and so on). You can reference values from the ConfigMap and secret too.

Go to sample YAML with source parameter to tune a resilience probe with source field configuration from the manifest.